Modify Selection
- Hazard prevention and control:
- Engineering controls
- or
- Fall protection
- or
- Temperature controls
- or
- Thermal insulation
- or
- Ground control
- or
- Span design
- or
- Pressure arch design
- or
- Entry design
- or
- Roof beam design
- or
- Scaling
- or
- Skin control
- or
- Support design and selection
- or
- Slope design
- or
- Highwall design
- or
- Pillar design
- or
- Facility design
- or
- Equipment design
- or
- Maintainability design
- or
- Workstation design
- or
- Tool design
- or
- Proximity detection
- or
- Electrical safety
- or
- Electrical contact protection
- or
- Lockout tagout
- or
- Grounding
- or
- Circuit protection
- or
- Short circuit protection
- or
- Ground monitoring systems
- or
- Overload protection
- or
- Electrical insulation
- or
- Dust control
- or
- Removal of deposited dust
- or
- Water infusion
- or
- Wet drilling
- or
- Mist drilling
- or
- Foam application
- or
- Sealing of dust sources
- or
- Filtration systems
- or
- Air curtain systems
- or
- Water spraying
- or
- Water mist systems
- or
- Wetting of deposited dust
- or
- Emission controls
- or
- Fuel additives
- or
- Engine derating
- or
- Diesel particulate filters
- or
- Low emission engines
- or
- Alternative fuels
- or
- Catalytic oxidation
- or
- Explosives safety
- or
- Explosives blending
- or
- Ventilation
- or
- Dilution ventilation
- or
- Push pull ventilation
- or
- Fan ventilation
- or
- Blowing ventilation
- or
- Ventilation control
- or
- Diffusion
- or
- Auxiliary ventilation
- or
- Exhaust ventilation
- or
- Recirculating ventilation
- or
- Scrubber induced airflow
- or
- Ergonomic design
- or
- Fire and explosion prevention
- or
- Permissible explosives
- or
- Ignition source elimination
- or
- Explosion proof design
- or
- Spark prevention
- or
- Nonsparking tools
- or
- Water curtains
- or
- Flameproof construction
- or
- Intrinsically safe design
- or
- Methane control
- or
- Degasification
- or
- Gob gas vent holes
- or
- Horizontal boreholes
- or
- Cross measure boreholes
- or
- Bleeder systems
- or
- Explosion suppression
- or
- Rock dusting
- or
- Rock dust barriers
- or
- Inerting atmosphere
- or
- Physical barriers
- or
- Lightning protection
- or
- Physical isolation
- or
- Automation
- or
- Improving visibility
- or
- Reducing glare
- or
- Improving visual contrast
- or
- Fire protection
- or
- Fire spread limitation
- or
- Fire detection
- or
- Smoke detection
- or
- Thermal detection
- or
- CO detection
- or
- Fire suppression
- or
- Noise and vibration control
- or
- Noise shielding
- or
- Vibration absorption
- or
- Noise damping
- or
- Vibration damping
- or
- Noise cancellation
- or
- Noise absorption
- or
- Mechanical isolation
- Document types:
- Conference papers
Home Links
Results 91 - 100 of 273
-
6/1/2008 - Conference papersIn this investigative study NIOSH measured for sub-micrometer elemental carbon (EC) using two types of control technologies (ventilation and cabs) which are being implemented in limestone mines.
-
6/1/2008 - Conference papersThis work attempts to provide rock mechanic tools that will enable a mine operator to make economic decisions that will also ensure a safe working environment.
-
6/1/2008 - Conference papersThe objective of the research was to cost-effectively increase the air cleaning volume and improve dust capture efficiency of an off-the-shelf dust collector with a larger motor and blower.
-
6/1/2008 - Conference papersThis study proposes a principle component analysis (PCA) and artificial neural network (ANN) approach to predict the ventilation methane emission rates of U.S. longwall mines and the optimum combination of degasification boreholes based on the given cha...
-
3/1/2008 - Conference papersSome surprising results were revealed in this study designed and implemented by NIOSH to evaluate the effectiveness of pre-driven longwall recovery rooms supported with pumpable concrete roof supports.
-
2/1/2008 - Conference papersThis NIOSH study presents an approach for prediction of methane inflow rates using coalbed methane reservoir modeling which can be used to limit the methane concentrations occurring as a result of the influences of various coalbed and operational parame...
-
2/1/2008 - Conference papersThis paper describes NIOSH research demonstrating that the ventilation of large-opening mines improves significantly by including ventilation requirements in the mine planning process and implementing some practical techniques during mining.
-
11/1/2007 - Conference papersThis paper details laboratory noise testing results of a continuous mining machine conveyor system which uses a coating for the tail roller designed to help bring the continuous mining machine into compliance with federal noise regulations.
-
11/1/2007 - Conference papersThis paper presents a summary of remote mine firefighting technologies used in U.S. underground coal mines and the results of completed NIOSH research in that area.
-
10/1/2007 - Conference papersThis paper evaluates the duty cycle of a typical roof bolting machine operation at two coal mines. The results provide insight into which portion of the operators’ duty cycle is the most prominent contributor to noise exposure.
Home Links
Content source: National Institute for Occupational Safety and Health, Mining Program